Install Prior to Siding
|
 |
Step 1
Remove the cap from the base. Remove the lower plate section by grabbing onto one of the bottom tabs and pull out from the base. Set aside to replace later.
|
 |
Step 2
Place the base over the water spigot and slide top plate spigot behind top of spigot collar. Nail base to wall. Note: There are 3 different diameter available to cut out of base: 1” (Pre-cut), 1 5/16” and 1 9/16”
|
 |
Step 3
Replace lower plate by sliding under spigot collar and top plate. Snap sides and bottom of lower plate firmly into the base.
|
 |
Step 4
After siding installation is complete snap cap back onto the base in provided holes.
|
 |
Step 5
Clean, finished appearance that hides cut edges of siding.
|
